Description
This document describes ValueRAM’s 1G x 64-bit (8GB)
DDR3L-1600 CL11 SDRAM (Synchronous DRAM), 2Rx8, low
voltage, memory module, based on sixteen 512M x 8-bit FBGA
components. The SPD is programmed to JEDEC standard
latency DDR3-1600 timing of 11-11-11 at 1.35V or 1.5V. This
204-pin SODIMM uses gold contact fingers. The electrical and
mechanical specifications are as follows:
FEATURES
- JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V) Power Supply
- VDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V)
- 800MHz fCK for 1600Mb/sec/pin
- 8 independent internal bank
- Programmable CAS Latency: 11, 10, 9, 8, 7, 6
- Programmable Additive Latency: 0, CL – 2, or CL – 1 clock
- 8-bit pre-fetch
- Burst Length: 8 (Interleave without any limit, sequential with starting address 000 only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
- Bi-directional Differential Data Strobe
- Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
- On Die Termination using ODT pin
- Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C
- Asynchronous Reset
- PCB: Height 1.18 (30mm), double sided component
SPECIFICATIONS
CL(IDD) : 11 cycles
Row Cycle Time (tRCmin) : 48.125ns (min.)
Refresh to Active/Refresh : 260ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) : 35ns (min.)
Maximum Operating Power : (1.35V) = 2.721W*
UL Rating : 94 V – 0
Operating Temperature : 0o C to 85o C
Storage Temperature : -55o C to +100o C
